Sand and stone separator machine structure


The product is compact in structure and simple in opera […]

The product is compact in structure and simple in operation. The control process can be manual and fully automatic, and the fault is fully displayed, which is convenient for transportation, installation and maintenance. The effective working area is spacious, and one or two cars can be unloaded and cleaned at the same time as needed.
Separation system: The spiral direction of the sieve tube is designed to be inclined at a horizontal angle, so that the material can be turned over during the limited screening process and washed and separated by the jet water stream. The reasonable arrangement of the height of the overflow trough in the upper part of the sedimentation tank of the sand dividing machine enables the sand and the mud to be sufficiently separated, and the conveying auger and the inner wall of the casing are asymmetrically installed. The accumulated layer of material can effectively prevent the abrasion, the spiral is lengthened, and the material can be transported. Fully dehydrated during the process. The sand is completely separated at one time. The separation ability may be 0-30 t/h.
Water supply and drainage system: The whole system cleaning process adopts cycle cleaning, so the sewage is basically zero emission and the water resource utilization rate is high.
Electronic control system: PLC control, more powerful functions, more convenient maintenance, fully automatic control process, full fault display and alarm. Improve the stability and reliability of the whole machine, all control modules are installed in the switch box that is not affected by the weather, and the fully automatic operation is easy to control and maintain.
Easy to operate: Pour the mixer into the set parking space, and then add the water to the feeding hopper. The slurry is poured into the hopper and cleaned and separated by the feeding hopper. The separated sandstone is sent to the sand outlet and the stone outlet respectively. The overflowing water flows through the drainage ditch to the sedimentation tank, passes through the third-stage sedimentation, is pumped back by the water pump, is recycled, and the mixer is cleaned for about five minutes. In addition, models of different specifications can be manufactured according to requirements.